mAcTX-LC-KIT

This partial kit enables you to replace a failed Macintosh LC/LC II/LC III/LC 475 power supply with an ATX-based PicoPSU (or any other ATX-based power supply). We've done the hard part and soldered down the surface-mount SOIC-8 MAX660, so you don't have to.

Here's what's Included:

* mAcTX LC Printed Circuit Board - ENIG plated
* MAX660 charge pump (voltage inverter for -5V), pre-soldered down
* 24-pin right-angle ATX connector (Molex 39-28-8240)
* 2x 10K Ohm resistors
* 2x 10uF Rubycon capacitors
* 2-pin header for power connector

What's NOT included (by default)
* PicoPSU
* Cabling to connect mAcTX LC to your LC-based computer. This would typically be salvaged from the original power supply, in most cases.
* SPST toggle switch (only needed if remote power control is desired).

Our mAcTX LC PCB kits are produced and sold with permission of the creators of this public-domain resource, by 'blusnowkitty' and 'compgeke'